Removing; Installation Settings; Setting The Direction - Epson EB-G7905UNL User Manual

Installing the Projector

Removing

Attention
When replacing the lens unit, remove the power plug from the electrical
outlet first. If the lens shift has been done, move the lens position to the
home position before replacing the lens unit.
s "Adjusting the Position of the Projected Image (Lens Shift)"
a
Pull the lens replacement cover straight out.
b
While holding the lens unit firmly, hold the lock lever and turn it
counterclockwise to unlock the lens unit.
Pull the lens unit straight out as it is released.

Installation Settings

Setting the direction

When installation is complete, set the Direction from the configuration
menu according to the vertical installation angle.
p.33
Attention
Make sure you set Direction correctly. If it is not set, the projector does not
cool down correctly, and the lamps may deteriorate.
a
Press the [Menu] button while projecting.
b
Select Direction from Extended.
c
Select Direction.
a
d
Use the [ ][ ] buttons to set the projector's installation angle.
Each time you press one of the buttons, the angle of tilt changes by
15 degrees. Set as close to the actual setup angle as possible.
• For portrait installation, set Portrait Mode to On.
s Extended - Direction - Portrait Mode
• For normal installation, set Portrait Mode to Off. When
Portrait Mode is On, you cannot set Direction.
• If the Portrait Mode setting is changed, the Power
Consumption and Brightness Level settings may change.
28
p.140