Epson EB-G7905UNL User Manual page 142

List of Functions
Submenu
Operation Direct Power On: Set to On to turn on the projector
simply by plugging it in.
When the power cord is plugged in, note that the projector
turns on automatically in cases such as a power outage
being restored.
Sleep Mode: When set to On, this automatically stops
projection when no image signal is being input and no
operations are carried out.
Sleep Mode Timer: When Sleep Mode is set to On, you
can set the time before the projector automatically turns off
within a range of 1 to 30 minutes.
High Altitude Mode: Set to On when using the projector
above an altitude of 1,500 m.
Auto Source Search: Set to On to automatically detect an
image signal from another source and project the image
when there is no image signal from the current source.
Auto Power On: If it is set to Computer or BNC, the
projector is turned on when the signals are received from
the Computer port or BNC port, even when the projector is
in standby status.
A/V Mute Settings: Peform settings related to A/V mute.
• Fade-in: Specify the number of seconds for fade-in when
displaying an image.
• Fade-out: Specify the number of seconds for fade-out
when hiding an image.
• A/V Mute Timer: When it is set to On, if no operations
are performed for about 2 hours after A/V mute is
activated, the projector turns off automatically.
• A/V Mute Release: When it is set to A/V Mute, you can
release A/V mute only by pressing the [A/V Mute] button
(or by sending an A/V mute Off command).
When set to Any Button, A/V mute is released when any
operation is performed on the projector.
Function Submenu
s "Hiding the Image and Sound Temporarily (A/V
Mute)" p.117
Advanced: The following items can be set.
• BNC Sync Termination: Set the termination for the
signal from the BNC port. This should usually be set to
Off. Set to On when analog (75Ω) termination such as for
switchers is necessary.
• Remote Control Type: You can select Normal or Simple
depending on the type of remote control.
Set this item to Normal to use the remote control
provided with this projector. When Simple is selected, you
can use the remote control provided with other Epson
projectors to operate this projector. This is useful if you
want to use a remote control that you are already familiar
with to operate the projector.
However, you cannot use the remote control provided
with this projector if this is set to Simple. Make sure that
the setting is correct because, if the projector is mounted
on the ceiling or somewhere hard to reach, changing it
back to Normal may be difficult. Additionally, you cannot
use the functions that are not equipped with this projector
or the remote control which you use.
• Beep: When this is set to On, the confirmation buzzer
beeps to notify you that the power turns on or off, or
cooling down is finished.
• Indicators: When set to Off, the projector's indicators are
turned off, except for abnormality or warning.
• Instant Off: When set to Enabled, the projector goes into
standby status in approximately three seconds after Power
Off. If you turn the power on immediately after turning it
off, command communication may be cut off. To stabilize
command communication, set this to Disabled. When set
142
Function