Table of Contents
Advertisement
Chapter 2
System Utilities
Most system are already configured by the manufacturer or the dealer. There is no need to run Setup when
starting the compurter unless you get a Run Setup message.
The Setup program loads configuration values into the battery-backed nonvolatile memory called
COMS RAM. This memory area is not part of the system RAM.
NOTE: If you repeatedly receive Run Setup messages, the battery may be bad. In this case, the system
cannot retain configuration values in CMOS. Ask a qualified technician for assistance.
Before you run Setup, make sure that you have saved all open files. The system reboots immediately after
you exit Setup.
As you change your BIOS Setup, examine the system configuration values. When you are satisfied that all
the values are correct, write them down. Store the recorded values in a safe place. In the future, if the
battery loses power or the CMOS chip is damaged, you can easily recreate your Setup.
Chapter 2
25
Advertisement
Table of Contents
