Troubleshooting Table Gas - Atag CG9271MB Instructions For Use Manual

FAULTS
Symptom
Fault code E2
Spontaneous changing of the
cooking setting.
Fault code U400
Fault code Er36
Fault code E7, Er13, Er20,
Er26, Er36, Er37 or Er39.

Troubleshooting table gas

Symptom
There is a smell of gas in the
vicinity of the appliance.
A burner does not ignite.
GB 26
Possible cause
- The electronics have
overheated. Possibly a too
large pan was placed in the
front right cooking zone.
- The hob is insufficiently
ventilated.
- The pan is too close to the
touch controls.
Overvoltage, 400V appliance
connected incorrectly.
Control panel overheated, the
pan is too close to the touch
controls.
Another defect.
Possible cause
There is a leak in the
connection of the appliance.
Plug not in socket.
Fuse defective/fuse in meter
cabinet switched off.
Sparkplug dirty/damp.
Burner parts not correctly
installed.
Solution
- Let the hob cool down until
the code disappears.
- Make sure the hob is
sufficiently ventilated.
- Keep the pan at a distance
of at least 2 cm from the
touch controls.
Connect appliance according
to connecting diagram to the
bottom of the appliance.
- Let the hob cool down.
- Keep the pan at a distance
of at least 2 cm from the
touch controls.
Contact the service
department.
Solution
Turn off the gas mains.
Contact the installation
company you employed.
Push the plug into the
socket.
Fit a new fuse or switch the
automatic fuse back on.
Clean and dry the sparkplug.
Assemble the burner parts
using the centring ridges.