Automatic Heat-Up Function - Atag CG9271MB Instructions For Use Manual

OPERATION CERAMIC

Automatic heat-up function

GB 18
• Touch and hold the - button for the kitchen timer/egg timer until
"01." shows in the display. Touch the - button again.
The kitchen timer is now in stand-by mode. The selected kitchen
timer automatically switches off after 10 seconds.
Switching off the kitchen timer/egg timer alarm
When the set time/cooking time has elapsed, the alarm rings and the
red light for the active kitchen timer/egg timer flashes "00".
• Touch any button to switch off the alarm.
Tip
• You can touch and hold the - button and the + button to set the
desired cooking time faster.
• If you press the - button immediately after switching on the kitchen
timer/egg timer, you can set the desired cooking time starting at 30
minutes (the display shows '30.').
The automatic heat-up function temporarily increases the power
(setting '9.') to heat the contents of the pan faster. This function is
available in all settings except setting '9.'.
Switching on the automatic heat-up function
The cooking zone is switched on and active.
• Use the + button to select setting 'A.' (comes after '9.').
'A.' and '9.' flash alternately in the display.
• Use the - or the + button to set the desired power.
If you select power setting 4, '4.' and 'A.' will flash alternately in the
display. (Attention! After 10 seconds, the cooking zone needs to be
reactivated before the + button can be used to increase the setting.
The - button then works as an off button).
• When the pan has reached the desired temperature, the automatic
heat-up function automatically switches off and the cooking zone
continues at the set power.
Tip
A quick way of setting 'A.' is by setting the cooking zone to '9.' using the
- button and then touching the + button once for setting 'A.'.