Faults; General; Troubleshooting Table Ceramic - Atag CG9271MB Instructions For Use Manual

FAULTS

General

Troubleshooting table ceramic

Symptom
A slight smell is noticeable
the first few times the hob is
used.
You can hear a ticking sound
in your hob.
A cooking zone suddenly
stops and you hear a signal.
The hob is not working
and nothing appears in the
display.
A fuse blows as soon as the
hob is switched on.
Fault code
Fault code
If you notice a crack in the glass top (however small), switch the hob
off immediately, unplug the hob, turn off the (automatic) fuse switch(es)
in the meter cupboard or, in the event of a permanent connection,
set the switch in the power supply lead to zero.) Contact the service
department.
If the appliance does not work properly, this does not always mean that
it is defective. Try to deal with the problem yourself first by checking
the points mentioned below.
Possible cause
The new appliance is heating
up.
This is caused by the
capacity limiter on the front
and back zones. Ticking can
also occur at lower settings.
The preset time has ended.
There is no power supply
due to a defective cable or a
faulty connection.
The hob has been wrongly
connected.
The control panel is filthy or
has water on it.
You touched 2 buttons at the
same time.
Solution
This is normal and will
disappear once it has been
used a few times. Ventilate
the kitchen.
Normal operation.
Switch off the audible sound
by pressing the + or - button
of the kitchen/ egg timer.
Check the fuses or the
electric switch (if there is no
plug).
Check the electrical
connections.
Clean control panel.
Operate 1 button at a time.
GB 25