Removal - NEC E120e-M User Manual

Chapter 2 Preparations
6. Fix the PCI card with the screw you removed in step 4.
7. Align the terminal part of the PCI riser card with the slot on the motherboard and insert it.
Fix the PCI riser card with three screws you removed in step 2.
8. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.
9. Make sure that no error messages are displayed on POST screen.
For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance
Guide".
10. Run the configuration utility of the mounted card to set up the board.
Availability or startup and operation procedure of the utility depends on card. For details, refer to the
manual that comes with the card. If a PCI card including RAID Controller and LAN adapter which
connects to any bootable device is added, the boot priority might be changed to the default
setting. In that case, configure the boot priority in Boot menu of BIOS Setup Utility. For details, refer to
Chapter 3 (2. System BIOS Setup).

1.9.4 Removal

To remove a PCI card, reverse the installation procedure.
Run SETUP and change boot order in Boot menu. Refer to Chapter 3 (2. System BIOS Setup) for how to
specify it.
If using the server while the card is removed, attach the blank cover that comes with the PCI riser card.
Note • Make sure that the head of a PCI card bracket is seated into the fixed slot of PCI riser
card.
• Depending on type of PCI cards, the terminal part of the PCI card may be too large to
fit in the connector.
• If you have trouble installing the board, remove the board once and try again. If you
apply excessive pressure on the board, a PCI card or riser card might break.
To connect a PCI card to the connector on motherboard with cable, connect a cable to PCI
Tips
card before installing PCI riser card.
Express5800/E120e-M User's Guide
1. Installing Internal Optional Devices
63