Changing Custom Erase Settings; Viewing Eraser Details - StarTech.com 8STSDOCK1EU3P2 User Manual

process is complete. If a serial printer is connected to the
eraser, a receipt prints out.
To remove the drive, press the Eject button.
8.

Changing Custom Erase Settings

You can customize the erase settings that are applied when
you select Custom Erase in the Eraser Mode menu, including
setting the number of passes and selecting a pattern number.
Use the Menu navigation buttons on the front of the eraser
1.
to move up and down in the Erase mode menu.
Select Custom Erase and press the OK button.
2.
Do any of the following:
3.
To select a pass number, select Setup Pass # and press the
•
OK button. Use the Menu navigation buttons to select a
number between 1 and 99 and press the OK button.
To select a pattern count, select Setup Pattern and press
•
the OK button. Use the Menu navigation buttons to select a
number between 1 and 99 and press the OK button. Use the
Menu navigation buttons to select a Data Pattern number
and press the OK button. Use the Menu navigation buttons
to select a number between 1 and 99. Press the OK button.
To return to the Erase mode menu, press the ESC button until
you have exited the Custom Erase settings.

Viewing Eraser Details

The SDOCK1EU3P2 includes a Utility menu that you can use to
view information about the eraser, including system and disk
information.
To view manuals, videos, drivers, downloads, technical drawings, and more visit www.startech.com/support
10