Table of Contents
Advertisement
Video wall installation guide
To ensure safety, please read this manual carefully before installation and follow the instructions
herein. Store this installation guide in a secure place for future reference.
At the end of this Installation Handbook are installation checklists that help you to ensure the
necessary steps have been completed. Make sure to have the checklists by hand before
performing a new installation.
Precautions
• The video wall must be installed on a flat and level surface which is strong enough to bear its
weight.
• If the video wall is mounted with mounting brackets, make sure the brackets are tightened
and secured on the wall and are strong enough to bear the weight of the video wall.
• The Liquid Crystal Display (LCD) panel of the display has a very thin protective layer of glass
which is liable to marking or scratching, and cracking if struck or pressured. Please protect
the display with cushions during video wall installation.
• Move a display by holding the handles on the back of the display. Do not touch the LCD panel
directly to avoid possible scratches.
• To maintain proper ventilation and heat dissipation, keep at least 60 mm of clear space from
the mounted displays to the wall.
• Ensure enough gap between displays to protect your LCD screens from the damage through
the direct transfer of weight. See
details.
Notes on moving the display
The display has limited mechanical strength. To prevent the display from performance failure
caused by line defects, front bezel bending, glass scratch/broken, light leakage, etc, it must be
handled with care. Refer to
Installing
You can cascade the displays in landscape or portrait mode as desired. Mind the space between
displays during installation.
Cascading displays in landscape or portrait mode
1. Install the mounting bracket to the wall following the instruction manual of the wall
mounting bracket. Make sure the mounting bracket is vertically and horizontally placed.
2. Attach the provided gap inspection pads to the display edges as instructed in Step 1~3 in
Checking the safe distance between displays on page
3. Mount and fasten the display on the mounting bracket or stand by tightening the screws
through the respective holes with a Phillips (cross) screwdriver. Do not place one display
directly on another as the stacked LCD screens may be damaged by the weight.
Checking the safe distance between displays on page 23
Notes on moving the display on page
5.
23.
Video wall installation guide
for
21
Advertisement
Table of Contents
Troubleshooting
