INSTALLING THE LEGS
Bertazzoni ranges must be used only with the
legs properly installed.
Four height‐adjustable legs are shipped with the
range in the polysterene container situated over
the appliance.
Before installing the legs, position the appliance
near its final location as the legs are not suitable
for moving the appliance over long distances.
After unpacking the range, raise it enough to
insert the legs in the appropriate receptacles
situated on the lower part of the appliance.
Lower the range gently to keep any undue strain
from legs and mounting hardware. If possible use
a pallet or lift jack instead of tilting the unit.
Adjust leg height to the desired level by twisting
the inside portion of the leg assembly until the
proper height is reached. Check with a level that
the cooktop is perfectly level.
INSTALLING THE WORKTOP
To increase the clearance between the front edge
of the worktop and the burners it is recomended
to install the worktop frontguard shipped with
the appliance. For installation instruction
followthe instruction indicated in the following
figures.
9
FRONTGUARD