Installing The Legs; Installing The Worktop Frontguard - Bertazzoni Master Series Installation, User And Maintenance Manual

INSTALLATION

INSTALLING THE LEGS

Bertazzoni ranges must be used only with the legs properly
installed.
Four height-adjustable legs are supplied with the range in
the polystyrene container situated over the appliance.
Before installing the legs, position the appliance near its
final location as the legs are not suitable for moving the
appliance over long distances. After unpacking the range,
raise it enough to insert the legs in the appropriate
receptacles situated on the lower part of the appliance.
Lower the range gently to keep any undue strain from legs
and mounting hardware. If possible use a pallet or lift jack
instead of tilting the unit.
Adjust leg height to the desired level by twisting the inside
portion of the leg assembly until the proper height is
reached. Check with a level that the cooktop is perfectly
level.
1
3
5
2
4
Fig. 14

INSTALLING THE WORKTOP FRONTGUARD

To increase the clearance between the front edge of the
worktop and the burners, it is possible to install a front
guard for the worktop.
• To install the front guard, locate the two fixing holes on
the end of the front guard.
• Locate the two fixing holes on the bottom facet of the
worktop.
• Fix the front guard with its two screws.
Fig. 15
21