Adding Salt - Sandstrom SID60W14N Installation Instructions Manual

Adding Salt

If the water in your area is hard, deposits will form on your dishes and utensils. As such, this appliance
contains a salt reservoir for you to reduce the hardness of the water.
Please follow the steps below to pour the salt into the salt reservoir and to correspond to the water
hardness level in your area.
1. Remove the lower basket and unscrew the reservoir cap.
2. Place the funnel provided over the salt reservoir. Pour in
approximately 1.2kg of dishwasher salt depending on the brand
used.
3. Fill the reservoir with water until it overflows (first use only).
4. Clean any excess salt from around the reservoir opening and then
screw the cap on again firmly.
5. Run the "Rapid" wash programme immediately (without any
crockery in the dishwasher) to remove any traces of salt from the
compartment.
• The salt refill warning indicator on the control panel will illuminate when the reservoir is running
out of salt and requires refilling.
• The salt refill warning indicator will cease to illuminate within a few days, depending on how
quickly the salt dissolves.
• If you decide to use a detergent tablet, you may not need to add salt, this depends upon the water
hardness in your area and the type of tablet being used. Check with your water supplier and the
detergent tablet manufacturers instructions.
open
open
GB
open
31