Table of Contents
Advertisement
Part 1 - Remote Setup
• Use FEN is a feature that allows you to register a
unique name for a camera that utilizes a dynamic
IP address to the FEN Server and connect to the
camera using the registered name instead of an IP
address, which can change from time to time. In
order to use this feature, you must first register a
FEN name to the FEN Server.
• If network settings have been changed, click OK
at the bottom of the setup window to save the
changes and then setup the FEN.
• Inquire with your network administrator for the FEN
Server's IP address or domain name. If a DNS server
has been configured under Network setup, you can
enter the FEN Server's domain name instead of its IP
address for the FEN Server setting.
• If using an IP router (or NAT), port configuration and
other network functions will depend on the usage
method of the IP router (or NAT).
• You will not be able to save FEN settings unless
you click on the OK button next to the FEN name
field and check the entered name's availability.
In addition, you will be prompted with an error
message if you do not enter a FEN name or enter
a name already registered to the FEN Server. If the
FEN name contains the #, \, and/or % symbol, it
might not be able to connect to the camera from
the IDIS Web program.
The FEN Server operated by IDIS is a service to its
clients and may go offline without notice for server
update purposes or due to an unexpected failure.
14
Port/QoS
• Use/Port: Enable/disable ports and designate
corresponding port numbers. Admin, Watch, and
Record ports are enabled by default and cannot
be disabled. By enabling IDIS Web and RTSP ports,
you will be able to use the IDIS Web program or
a media player that supports RTSP (Real-Time
Streaming Protocol) service to connect to the camera.
If this option has been changed, Remote Setup
will terminate after applying the current settings.
(Applicable to Admin port number only.)
• DSCP: Designate each port's QoS (Quality of Service)
level using DSCP values. Assigning QoS levels
prioritizes the ports for network bandwidth use.
Higher the DSCP value, higher the QoS level and thus
higher on the network bandwidth allocation priority
list. Use 0
if you do
not want to assign a QoS level. The
network environment must support DSCP in order
for this feature to function properly. Contact your
network administrator for more details.
Advertisement
Table of Contents
