Table of Contents
Advertisement
1. Install the server and cable management arm into the rack. For more information, see the
installation instructions included with the 1U Slide Rail System.
2. Connect peripheral devices to the server.For connector identification information, see
"Rear panel components" in this guide.
WARNING:
To reduce the risk of electric shock, fire, or damage to the equipment, do not
plug telephone or telecommunications connectors into RJ-45 connectors.
3. Connect the power cord to the rear of the server.
4. Connect the power cord to the AC power source.
WARNING:
To reduce the risk of electric shock or damage to the equipment:
• Do not disable the power cord grounding plug. The grounding plug is an important safety
feature.
• Plug the power cord into a grounded (earthed) electrical outlet that is easily accessible at
all times.
• Unplug the power cord from the power supply to disconnect power to the equipment.
• Do not route the power cord where it can be walked on or pinched by items placed against
it. Pay particular attention to the plug, electrical outlet, and the point where the cord
extends from the server.
5.6 Installing the Operating System
To operate properly, the server must have a supported operating system installed. For the
latest information on supported operating systems, refer to the Inspur website (http://www.
inspur.com).
To install the operating system on the server, you can download from the official website
directly.
20
Advertisement
Table of Contents
