Warnings!
The cabinet, chassis or rails may cause serious scratches, please
be careful while handling.
When installing new servers into the cabinet in use, please be
aware of electric shock.
●
During the installation process, please do not block the vents on the server, especially the
vents on the front and rear of the server.
●
Please remove the protective film from the server surface before using.
●
Please leave a minimum of 15cm clearance on the front and rear sides of the server for
proper ventilation.
●
Please install air baffles in place prior to device installation, to make sure that the server can
get enough air flow, and to avoid air turbulence in the server room.
●
Servers are high-power electrical appliances, and they should be installed into dedicated
cabinets with vents or professional water-cooled cabinets, to prevent system failures
caused by overheating.
●
If it needs to install more than one device, please load them from the bottom to the top,
and load the heaviest items first.
●
Please note the cabinet' s load-bearing capacity, power supply capacity and heat
dissipation capacity, be sure not to install devices beyond the cabinet' s threshold capacity.
●
For the convenience of using the front and rear ports of the server and cabling, leave a
minimum clearance of 70mm between the front end of the server and the inner side of the
cabinet' s front door, and 150mm between the rear end of the server and the inner side of
the cabinet' s rear door.
If the device is more than 15kg, at least 2 people are needed.
15kg
If the device is more than 30kg, at least 3 people are needed.
30kg
If the device is more than 50kg, at least 4 people are needed.
50kg
Please keep this document for future reference.
V01502T000000000
Rack-Mounted Server
Installation Guide
V1.0