Pedigo P-2150 Operator's Manual page 40

M
AINTENANCE
Yearly
40
Continued from previous page
For yearly maintenance, do the following.
Check:
▪
the set-point temperature compared to the actual temperature displayed.
Check the cavity air temperature with a thermocouple placed 1" (25mm) from
□
the cavity sensor. Do not allow the thermocouple to touch any surface.
Monitor the temperature for approximately one hour in an empty cavity.
▪
the condition of the plug and cord and replace if damaged.
▪
the controller screen for excessive wear. Make sure the controller screen displays
and operates properly.
Clean:
▪
the shelves and interior of the warmer. See topic How to Clean the Warmer for the
list of approved cleaners.
Co m b i n at i on B l an k e t/ F l u id W a rm e r Op er a to r ' s Ma n u al M N- 39 9 3 0
▪ ▪
Rev 2 4/ 2 0
▪ ▪