Pedigo P-2150 Operator's Manual page 36

O
PERATION
Result
Viewing the
temperature data
36
Continued from previous page
2. Plug the USB drive into the port
data.
NOTICE
The warmer goes through the download process:
The LED screen located above the USB port flashes for a few seconds to
▪
show a data transfer is in progress.
The LED screen stops flashing.
▪
The download is complete.
▪
3. Remove the USB drive from the port.
4. Close the blanket warmer door.
The data has now been downloaded.
To view the temperature data, do the following.
5. Plug the USB drive into a computer.
6. Double-click on the file.

NOTE:
datalog_MMDDYY_HHMMSS.csv.
Sort
7. the data as necessary.
Temperature data will be recorded in the same temperature units that are
displayed on the LED screen.

NOTE:
use by service technicians only.
Co m b i n at i on B l an k e t/ F l u id W a rm e r
a . The warmer downloads the temperature
Do not remove the USB drive during the download
process.
a
Data is stored on the USB drive in a file named,
Errors recorded by the warmer are intended for
Op er a to r ' s Ma n u al
▪
EC-TS-005823
Continued on next page
M N- 39 9 3 0 Rev 2 4/ 2 0
▪ ▪ ▪