Refer to the wire diagram located under the lid of the appliance Limited Warranty back cover Pedigo Products, Inc. • 4000 S.E. Columbia Way • Vancouver, WA 98661 • U.S.A. Phone: 800.822.3501 • Fax: 360.696.1700 • www.pedigo-usa.com MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
4. Remove all protective plastic fi lm, packaging materials, and accessories from the appliance before connecting electrical power. Store any accessories in a convenient place for future use. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
A temporary odor may be noticeable upon initial MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer start-up of the appliance. Contact manufacturer if the odor persists a er a day or more of continuous...
fl uid warmers. distribution throughout the cavity • Four (4) non-skid rubber feet are standard MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Type B Equipment 220-230V Plug IPX-0 Other international plugs are available, contact the manufacturer for more information. Domestic ground shipping information. Contact factory for export weight and dimensions. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 9
IEC 61000-4-8 NOTE: UT is the a.c. mains voltage prior to application of the test level. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 10
NOTE: 1. At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies. 2. These guidelines may not apply in all situations. Electromagnetic propagation is aff ected by absorption and reflection from structures, objects and people. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 11
When acknowledging a power interruption, the display will show the length of time in hours and minutes that the control has been off due to the power outage. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Volume settings range from two choices. 0 (mute)to 12 (loud). NOTE: The alarm volume is set at the maximum (12) and can not be disabled. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 13
NOTE: Setting the day code is optional unless the user configures the auto-timer to start or stop at a diff erent time for each day of the week. Typically Monday=d1, Tuesday=d2, etc. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 14
3. When both times are set, allow the on/off indicator light to extinguish and then press and hold the Timer On/Off button until the on/off indicator light stays on steadily. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 15
7. Rotate load of blankets daily Rotate the blankets at the bottom of the load to the top to ensure equal usage. Failure to rotate the blankets can cause the blankets to discolor. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Page 16
8. Replace the support assembly. minimum of once per day. Always wipe standing water as quickly as possible. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
1" (25mm) from the cavity sensor – not allowing it to touch any surface. Monitor for approximately one hour in an empty interior. NOTE: Blanket warmer temperature may fluctuate ±10°F (6°C) from set point. *Contact service for immediate repair MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer...
Contact service. E-60 Real Time Clock MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Real time clock rechargeable battery backup has discharged. Checksum Error •...
Page 32
Call service The serial number is required for all inquiries. not locked MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any *E-83 EEPROM Error Call service for help resetting the control.
(right side) Zone 3 (bottom) The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance. Model: ______________________________________________...
Page 34
Service Kit for EL-39472 5027940 — 5027940 — — The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance. Model: ______________________________________________...
Page 35
1014285 Rear cover, 1.5 5013520 The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance. Model: ______________________________________________...
Page 36
Door assembly, stainless steel w/ lock, 7.5 5018264 Cover, door CONTACT FACTORY The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance.
Page 37
Plug, .5" pry out (not shown) PG-39535 The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance.
Page 38
Bushing, snap, 1-1/2" BU-3013 Bushing, snap, 7/8", black BU-3007 The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance.
Page 39
Washer, flat M4 18-8 s/s WS-22294 Housing, latch spring support 1011163 The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance.
Page 40
Washer, flat WS-25056 Overlay, auto timer (optional) PE-34864 The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance.
Page 41
Screw, M4 x 0.7 x 10mm pan SC-22273 The serial number is required for all inquiries. MM-1077 (MN-37073) • Rev 3 • 12/18 • Elite Series Blanket Warmer Always include both model and serial number(s) in any correspondence regarding the appliance.
Limited Warranty Pedigo Products, Inc. warrants to the original purchaser that any original part that is found to be defective in material or workmanship will, at our option, subject to provisions hereinaft er stated, be replaced with a new or rebuilt part.