Table of Contents
Advertisement
Server Matching
You can set the server matching. When this option is activated, it performs user authentication matching in BioStar 2, not
in the device. It can be used when the device has too much user information or when the device is installed outside.
1
Press
and authenticate with the Admin level credential.
2
Select AUTHENTICATION and activate Server Matching (Fingerprint, Card, ID)
NOTE
It is only available for fingerprint, card and ID options.
•
•
When you use the server matching option, you need to activate the option in both Biostar 2 and the device. Refer to the
administrator manual of BioStar 2 to learn how to set the server matching settings in BioStar 2.
Face
You can change settings regarding the face authentication.
3
Press
and authenticate with the Admin level credential.
4
Select AUTHENTICATION > Face.
5
Select and set the desired item.
Ambient Brightness: Detect the ambient brightness and adjust the intensity of IR LED. Change settings according to the
•
installation environment.
Motion Sensor: Set the sensitivity for detecting motion near the device. If Motion Sensor is set to OFF, tap the screen to
•
authenticate the face.
Enroll Timeout: If a face is not registered during the set time, the face registration will be canceled.
•
Auth Timeout: If the authentication is not completed during the set time, the authentication will fail.
•
Duplicate Check: When registering a face, you can check duplicates.
•
•
Face Detect Setting: set the face recognition area by adjusting the size and position of the detected area.
NOTE
It is recommended to maintain the default values of options under Face Detect Setting. The default values of each option
•
are as follows:
-
Maximum Head Rotation Angle: 15
-
Minimum Face Width: 66
.
Advertisement
Table of Contents
