Correct face registration and authentication method
Cautions for registering a face
When registering a face, maintain a distance of 60 cm to 100 cm between the device and the face.
•
Do not change your face expression.
•
Do not wear masks, hats, or eye patches.
•
Do not raise head up or lower head.
•
Do not close your eyes.
•
•
Do not wear thick makeup.
Be careful not to display two faces on the screen. Register one person at a time.
•
If you do not follow the instructions on the screen, the face registration may take longer or may fail.
•
Cautions for authenticating a face
Ensure that the face appears in the center of the device's screen. When the guideline is displayed, follow the
•
instructions shown on the screen to authenticate the face.
If a part of the face is covered with a hat, a mask, an eye patch, or sunglasses authentication may fail. Do not cover the
•
face; allow the device to recognize both the eyebrows and the face.
How to enroll a fingerprint
In order to improve the fingerprint authentication rate, register the fingerprint correctly. FaceStation F2 can recognize a
fingerprint even if the angle and position of a user's fingerprint input change. If you register the fingerprint with attention
to the following matters, the authentication rate can be improved.
Selecting a finger for fingerprint input
In preparation for the case that the fingerprint of a specific finger cannot be used, for
•
example if the user is lifting a load with one hand or a finger gets hurt, up to 10
fingerprints for each user can be registered.
•
In the case of a user whose fingerprint cannot be recognized well, the authentication
rate can be improved by enrolling the same finger twice repeatedly.
•
If a finger has a cut or the fingerprint is blurry, select another finger for the
fingerprint.
It is recommended to use the index finger or the middle finger when scanning the
•
fingerprint. The authentication rate can be reduced if it is difficult to place another
finger at the center of fingerprint sensor accurately.