Registering A Fingerprint - suprema FSF2ODB User Manual

• Extended Private Auth Mode: Change the authentication method according to the user. You can set whether to use the
extended private auth mode. this mode allows you to combine user authentication methods, including both faces and
fingerprints. Otherwise, you can use the device's basic authentication mode. You can modify it in BioStar 2.
3
To save settings, press OK.
Registering a face
1
Press and authenticate with the Admin level credential.
2
Select USER > .
3
Select Face > Next.
4
Adjust a distance between the face and screen and look straight at the camera of the device.
5
Once your face is captured successfully, press OK > Save. To retake a photo, press Re-Shot.
NOTE
The visual face data of FaceStation F2 are not compatible with face templates of FaceStation 2 or FaceLite.
•
You can register Visual Face not only directly from FaceStation F2 but from the BioStar 2 by uploading photos or importing
•
CSV files. You can also register Visual Face with your smartphone via a link sent from BioStar 2. To learn more about how to
register Visual Face for each method, please refer to the BioStar 2 help manual.
To use a Visual Face feature correctly, take a picture by following instructions below.
•
- When registering a face, maintain a distance of 60 cm to 100 cm between the device and the face.
- Do not change your face expression.
- Do not wear masks, hats, or eye patches.
- Do not raise head up or lower head.
- Do not close your eyes.
- Do not wear thick makeup.
- Be careful not to display two faces on the screen. Register one person at a time.
- If you do not follow the instructions on the screen, the face registration may take longer or may fail.

Registering a fingerprint

1
Press and authenticate with the Admin level credential.
2
Select USER > .
3
Select Fingerprint > Next.
4
Scan your fingerprint and verify the same fingerprint again.
NOTE
Place the finger deep enough to contact with the sensor completely.
•
Place the center of the fingerprint in the center of the sensor.
•
If a finger has a cut or the fingerprint is blurry, select another finger for the fingerprint.
•
Scan the fingerprint correctly without moving according to the instruction on the screen.
•
If you make the finger upright so that the contact area with the sensor is decreased or the angle of finger is warped,
•
fingerprint authentication may not be performed.