Table of Contents
Advertisement
NO
Name
Def.
Valid
.
0
0
0
PIR Re-
Detect
8
3
1 ~ 127
Interval
Time
Turn Off
9
Light
4
0 ~ 127
Time
Auto
Report
10
12
0 ~ 127
Battery
Time
20
30
Auto Report
-128~127 The interval time for auto report each tick.
Tick
Interval
Description
Bit5: Disable Multi CC in auto report.
(1:Disable, 0:Enable)
Bit6: Disable to report battery state when
the device triggered. (1:Disable, 0:Enable)
Bit7: Reserve.
In the normal mode, after the PIR motion
detected, setting the re-detect time. 8
seconds per tick, default tick is 3 (24
seconds).
Setting the suitable value to prevent received
the trigger signal too frequently. Also can
save the battery energy.
Notice: If this value bigger than the
configuration setting NO. 9. There is a period
after the light turned off and the PIR not
start detecting.
After turn on the lighting, setting the delay
time to turn off the lighting when the PIR
motion is not detected. 8 seconds per tick,
default tick is 4 (32 seconds).
0 means never send turn off light command.
The interval time for auto report the battery
level.
0 means turn off auto report battery.
The default value is 12. The tick time can
setting by the configuration No.20.
Setting this configuration will effect
configuration No.10.
NO
Name
Def.
Valid
.
Specifications
Power by CR123A lithium battery.
Signal (Frequency):
868.40 MHz, 869.85 MHz(EU),
908.40 MHz, 916.00 MHz(US),(Canada)
922~927 MHz(JP/TW),
921.40 MHz, 919.80 MHz(ANZ),
869.00 MHz(RU),
865.20 MHz(IN),
916.00 MHz(IL),
RF Maximum Power: +5dBm
Range:
Minimum 40 meters indoor, 100 meters outdoor line of sight.
Operating Temperature: -10
Specifications subject to change without notice due to continuing
product improvement.
7
Description
The unit is 1 minute.
Caution1: Setting to 0 means turn off all
auto report function.
Caution2: The range is from 0x00~0xFF
using hexadecimal notation.
o
C ~ 40
o
C For indoor use only.
Advertisement
Table of Contents
