Philio PSP05 Quick Start Manual page 6

NO
Name
Def.
Valid
.
Basic Set
2
-1
All
Level
3 PIR
80
0 ~ 99
(*) Sensitivity
6 Mult-
(*) Sensor
5
All
Function
Switch
0
0
1
0
Description
Setting the BASIC command value to turn on
the light. -1(0xFF) means turn on the light.
For dimmer equipment 1 to 100 means the
light strength.
0 means turn off the light.
Caution: The range is from 0x00~0xFF
using hexadecimal notation.
PIR sensitivity setting.
0 means disable the PIR motion.
1 means the lowest sensitivity,
99 means the highest sensitivity.
High sensitivity means can detected long
distance, but if there is more noise signal in
the environment, it will re-trigger too
frequency.
Multisensor function switch. Using bit to
control.
Caution: The range is from 0x00~0xFF
using hexadecimal notation.
Bit0: Reserve.
Bit1: Reserve.
Bit2: Reserve.
Bit3: When Bit2 is 0 (Enable), Are the device
and the lighting in the same room?
0: In the same room(Default),
1: In the different room.
Notice: If this bit is 1, it is recommended
also set the Bit1 to 1, cause the PIR
triggered, doesn't mean the people in that
room.
NO
Name
Def.
Valid
.
0
0
0
0
7 Customer
(*) Function 4
0
0
1
0
0
6
Description
Bit4: Disable delay 5 seconds to turn off the
light, when door/window closed. (1:Disable,
0:Enable)
Bit5: Disable auto turn off the light, after
door/window opened to turn on the light.
(1:Disable, 0:Enable)
Notice: If bit2 is zero, this setting is useless.
Notice: If the configuration No.9 is zero,
this setting is useless.
Bit6: Reserve.
Bit7: Reserve.
Customer function switch, using bit control.
Caution: The range is from 0x00~0xFF
All
using hexadecimal notation.
Bit0: Reserve.
Bit1: Enable sending motion OFF report.
(0:Disable, 1:Enable)
Note: Depends on the Bit4,
0: Report Notification CC,
Type: 0x07, Event: 0xFE
1: Sensor Binary Report,
Type: 0x0C, Value: 0x00
Bit2: Enable PIR super sensitivity mode.
(0:Disable, 1:Enable)
Bit3: Reserve.
Bit4: Notification Type,
0: Using Notification Report.
1: Using Sensor Binary Report.