Fantasea Line FA6500 V2 Instruction Manual page 34

e. Pull the housing Mode Dial up and away from the
housing to allow for smooth installation of the
camera (image #46).
10. Install the tray with camera into the camera tray port by
holding the tray parallel to the housing, aligning the rods of
the tray with those featured on the tray port and sliding the
tray all the way in (image #47).
11. Turn the camera tray port lock leftwards, to the "LOCK"
position (image #48). Make sure that the tray was properly
installed and locked by gently trying to pull it
out.
12. Realign the camera LCD screen by slightly
pushing its bottom inwards and pulling its top
outwards until it reaches a complete vertical
angle (image #49).
13. If making use of any electronic triggers, such as a
LED Flash Trigger or an electronic strobe
bulkhead, attach the accessory to the camera
hot-shoe connection.
14. If inserting a silica gel pack inside the housing in order to prevent moisture, it is best to insert it
on the left side of the camera and to attach it
with tape to the housing wall, where it doesn't
interfere with proper housing operation. It is
important to make sure that the silica gel pack
doesn't stick out, or else it might interfere with
the watertight seal of the housing.
15. If making use of a Vacuum System, make sure it
is fully charged and turn it on prior to closing the
housing (see section "Hybrid Vacuum Safety
System").
16. Close the housing (see section "Closing the
Housing").
17. When using an exceptionally large lens, you
might find that the lens cannot be installed on
the camera prior to inserting it into the housing,
as the lens is too large to be fully inserted inside
the housing port hole. In such cases, the lens
Image #46
Image #47
Image #48
Realign camera LCD screen
Image #49
FA6500 V2 Housing Instruction Manual 20190402
34