Snmp; Firmware Upgrades; Password Recovery - Dataprobe iBootBar iBB-DC8 Installation And Operations

9.7.

SNMP

Up to four SNMP managers can be set. Each manager will receive Trap notifications for outlet changes, autoping
and current alarms. Set the SNMP manager IP addresses using the
Enable or Disable SNMP for any manager with the
distribution CD, or at
The iBootBar also supports the following elements of MIB-II
mgmt [1.3.6.1.2]
|
-> [ 1] -BR- mib-2
|
-> [ 1] -BR- system
|
-> [ 1] *RO* DisplayString
-> [ 2] *RO* OBJECT IDENTIFIER
-> [ 3] *RO* TimeTicks
-> [ 4] *RW* DisplayString
-> [ 5] *RW* DisplayString
-> [ 6] *RW* DisplayString
-> [ 7] *RO* INTEGER
9.8.

Firmware Upgrades

The iBootBar can be upgraded via the network if the upload feature has been enabled using the
command on the console interface. To upgrade the iBootBar download the latest version of the firmware and
upgrade utility from the Dataprobe website.
9.9.

Password Recovery

Holding the reset button on the front panel of the iBootBar for 5 seconds or longer will initiate a password recovery
mode. Once the reset button is released, the user has 30 seconds to log in to the CLI using the username
admin
and password
V180808N
http://dataprobe.com/support-ibb-dc8
http://dataprobe.com/support-ibb-dc8
. Upon accessing the CLI, change the username and password for User 1 as desired.
iBB-DC8 Manual
set snmp <n> ipaddress <dotted decimal>
set snmp <n> enable <yes/no>
command. The MIB is available on the
sysDescr
sysObjectID
sysUpTime
sysContact
sysName
sysLocation
sysServices
command.
Truncated to 128 Char
Truncated to 128 Char
Truncated to 128 Char
set upload enable yes
admin
Page 30