Timed Events - Dataprobe iBootBar iBB-DC8 Installation And Operations

9.2.

Timed Events

The iBootBar provides the ability to turn On, Off or Cycle outlets based on time and date. Each individual outlet or
group can be set to operate a selected command at a specific time and date. The Timed Events are programmed
thru the Control & Setup Utility or the CLI interface. Up to 16 events can be created.
Each event can be assigned to one outlet or group and repeated on a regular basis.
Administrative rights are required to set up and manage any event. To add an event, create the event, assign the
event to a specific outlet or group and then configure the initial occurrence of the event, the action to be performed,
and the repeat frequency, if desired.
To configure the timed events, use the following commands:
get events
get event <eventname>
add event <eventname>
dev event <eventname>
ren event <eventname> <new name>
set event <eventname> year <2007 – 2050>
set event < eventname> month <1-12>
set event <eventname> day <1-31>
set event <eventname> hour <0-23>
set event <eventname> minute <0-59>
set event <enentname> action <on/off/cycle>
set event <eventname > repeat < never / daily / weekly / monthly / annually>
set event <eventname> control outlet <1-8>
set event <eventname> control device <#1-#16/devname> outlet <1-8>
set event <eventname> control group <groupname>
V180808N iBB-DC8 Manual Page 25