Dataprobe iBootBar iBB-DC8 Installation And Operations page 18

set unit <hwkey> device <2-16>
set factory defaults
logout
reboot
iBootBar iBB-DC8 V1.5x
Sets the ID of a remote device in cluster configurations. The harware key
<hwkey> is the last 2 bytes of the MAC address NO spaces, dashes or colons.
Resets all parameters to their factory settings including the IP Address. Only
available on the serial port. Confirmation is required. Note: This command can
take up to 30 seconds to execute.
Ends the session
Reboots the selected iBootBar. This will not change the status of the outlets.
In this example, the
<hwkey>
is 38A2
Page 18
Yes
Yes
No
Yes