Billion BEC MX-1000 User Manual page 98

IPSec Phase 2(IPSec)
IPSec Proposal: Select the IPSec security method. There are two methods of verifying the
authentication information, AH(Authentication Header) and ESP(Encapsulating Security Payload).
Use ESP for greater security so that data will be encrypted and the data origin be authenticated but
using AH data origin will only be authenticated but not encrypted.
Authentication Algorithm: Authentication establishes the integrity of the datagram and ensures it is
not tampered with in transmission. There are 3 options: Message Digest 5 (MD5) and Secure Hash
Algorithm (SHA1, SHA256). SHA1 is more resistant to brute-force attacks than MD5. However, it is
slower.
 MD5: A one-way hashing algorithm that produces a 128−bit hash.
 SHA1: A one-way hashing algorithm that produces a 160−bit hash.
Encryption Algorithm: Select the encryption algorithm from the drop-down menu. There are several
options: DES and AES (128, 192 and 256). 3DES and AES are more powerful but increase latency.
 DES: Stands for Data Encryption Standard, it uses 56 bits as an encryption method.
 3DES: Stands for Triple Data Encryption Standard, it uses 168 (56*3) bits as an encryption
method.
 AES: Stands for Advanced Encryption Standards, you can use 128, 192 or 256 bits as
encryption method.
Perfect Forward Secrecy: It is a public-key cryptography protocol that allows two parties to establish
a shared secret over an unsecured communication channel (i.e. over the Internet). MODP stands for
Modular Exponentiation Groups.
IPSec SA Lifetime
SA Lifetime: Specify the number of minutes that a Security Association (SA) will stay active before
new encryption and authentication key will be exchanged. There are two kinds of SAs, IKE and IPSec.
IKE negotiates and establishes SA on behalf of IPSec, an IKE SA is used by IKE.
 Phase 1 (IKE): To issue an initial connection request for a new VPN tunnel. The range can be
from 5 to 15,000 minutes, and the default is 480 minutes.
 Phase 2 (IPSec): To negotiate and establish secure authentication. The range can be from 5 to
15,000 minutes, and the default is 60 minutes. A short SA time increases security by forcing the
two parties to update the keys. However, every time the VPN tunnel re-negotiates, access
through the tunnel will be temporarily disconnected.
IPSec Conneciton Keep Alvie
Keep Alive:
 None: The default setting is None. To this mode, it will not detect the remote IPSec peer has
been lost or not. It only follows the policy of Disconnection time after no traffic, which the remote
IPSec will be disconnected after the time you set in this function.
 PING: This mode will detect the remote IPSec peer has lost or not by pinging specify IP