Replacement - Procom FBN400RHA Series Owner's Operation And Installation Manual

Burner does not light after ODS/pilot
is lit
Delayed ignition burner
Burner backfiring during combustion
Slight smoke or odor during initial
operation
Dark residue on logs or inside of
fireplace
Heater produces a clicking/ticking
noise just after burner is lit or
shut off
REPLACEMENT PARTS
NOTE: Use only original replace-
ment
parts. This will protect your warranty
coverage for parts replaced under
warranty.
PARTS UNDER WARRANTY
Contact authorized dealers of this
product. If they can't supply original
replacement part(s), call ProCom's
toll free number at (1-877-886-5989)
for referral information.
W hen calling ProCom or your
dealer, have ready:
TROUBLESHOOTING
Continued
1. Burner orifice clogged
2. Inlet gas pressure is too low
3. Burner orifice diameter is too
sm all
4. Thermocouple leads discon-
nected or improperly connected
5. Burners will not come in
remote position
1. Manifold pressure is too low
2. Burner orifice clogged
1. Damaged burner
2. Gas regulator defective
1. Residues from manufacturing
processes
2. Not enough air
3. Gas regulator defective
1. Improper log placement
2. Air holes at burner inlet blocked
3. Burner flame holes blocked
1. Metal expanding while heating
or contracting while cooling
REPLACEMENT PARTS
l Your name
l Your address
l Model and serial numbers
of your heater
l How heater was malfunctioning
l Type of gas used (propane/LP or
NG)
l Purchase date
l Warranty card
Usually, we will
to return the defective part to the
factory.
17
1 7
1.Clean burner (see Cleaning
and Maintenance, page 13) or
replace burner orifice.
2. Contact
gas company
3. Replace burner orifice
4. Reconnect leads (see wiring
diagram)
5. Replace battery in transmitter
and receiver
1. Contact local gas company
2. Clean burner (see Cleaning and
Maintenance, page 13)
1. Clean burner orifice (see
Cleaning and Maintenance, page
13)
2. Replace gas regulator
1. Problem will stop after a few
hours of operation
2. Check burner for dirt and debris.
If found, clean burner (see Cleaning
and Maintenance, page 13)
3. Replace gas regulator
1. Properly locate logs (see installing
logs, page 10)
2. Clean out air holes at burner inlet.
Periodically repeat as needed.
3. Remove blockage or replace burner
1. This is common with most
heaters. If noise is excessive,
contact qualified technician.
PARTS NOT UNDER
WARRANTY
Contact authorized dealers of this
product. If they can't supply original re-
placement part(s) call ProCom's toll free
number at (1-877-886-5989) for referral
information.
When calling ProCom, have ready
l Model number of your heater
l The replacement part number
ask you
local propane/LP