Clock And Date Setting; Alarm Setting - LEXIBOOK WB400RX Instruction Manual

Atmosphere station

Hide thumbs

Table Of Contents

Table of Contents

Available languages

3. Use

matches the sensor you want to receive information from. The data of the

corresponding remote sensor will be displayed in idle mode. The selected

channel must be the same as the one chosen for the remote sensor with the

channel selector. If the channels are different, the main unit will not be able

to receive the data sent by the sensor. The weather station will automatically

detect the new sensors.

4. Press

to confirm your selection.

MODE

Note:

• If the sensor (or the main unit) is too close to other electrical devices,

interference may cause malfunction. You can change the channel on the

sensor and main unit as described above to improve the reception.

• It may take up to 3 minutes before the main unit displays the readings.

• After a few seconds of inactivity, the main unit will go back to normal mode.

• If the sensor is exposed to very low temperatures for an extended period of

time, the batteries may lose power, which may cause the transmission range to

be limited. High temperatures also reduce the battery performance.

Clock setting

1. In normal mode (idle screen), press

2. Press and hold

3. Use

and adjust the next setting.

4. The setting sequence is displayed in the following order:

Hours

Minutes

(Day/Month) or MD (Month/Day) display

Note: When the DST function is turned on,

5. Press

to confirm your selection and go back to normal mode (idle

MODE

screen).

You can set the alarm to sound with a beep tone without the light display or 1 of

the 4 music themes with a light display.

1. In normal mode (idle screen), press

2. Use

alarm is turned on.

3. Press and hold

to select the outdoor channel (