Table of Contents
Advertisement
Terminal Panel
A
AC IN Connector
Connects with the supplied power cord.
B
Main Power Switch
On/Off switch to turn main power ON/OFF.
C
Audio IN
Audio signal input from external equipment such as a
computer or player.
D
DisplayPort OUT
Output DisplayPort signals from DisplayPort IN1.
You can connect multiple monitors by using DisplayPort
daisy-chain connection. See [MULTI DISPLAY]
Video out
(page
67).
E
DisplayPort IN1/IN2
DisplayPort signals input.
F
HDMI IN1/IN2/IN3
HDMI signals input.
G
RS-232C IN (D-Sub 9 pin)
Connect RS-232C input from external equipment, such as a
computer, in order to control RS-232C functions. See
H
Remote IN
Use the optional sensor unit by connecting it to your monitor.
NOTE: Do not use this connector unless specified.
I
microSD Card Slot
microSD memory card reader for use with the Media Player
(See
page
22).
To install the microSD card slot cover, please refer to
"Installing microSD card slot cover" (See
J
USB1:
USB2:
USB CM1 (2A): Power supply port.
USB CM2*: Service port. Please do not connect devices.
* USB functionality is available when the optional Raspberry
Pi Compute Module Interface Board and Raspberry Pi
Compute Module are installed.
USB MP:
(page
38) and
K
Connect to LAN in order to manage and control the monitor
over the network. See
NOTE: Please give priority for use to LAN1.
L
page
48.
Audio signal output from the AUDIO IN, DisplayPort and
HDMI to an external device (stereo receiver, amplifier, etc.).
NOTE: This connector is not a Headphone terminal.
M
NOTE: Please turn off the monitor's main power when you
use the Internal/External speaker switch.
N
page
22).
Audio signal output.
Red terminal is plus (+).
Black terminal is minus (-).
NOTE: This speaker terminal is for 15 W + 15 W (8 ohm)
speaker.
English-10
USB Port
Downstream port (USB Type-A).
Connect USB devices.
Upstream port (USB Type-B).
Connect external equipment such as a
computer.
To control the monitor from connected external
equipment, please use this port.
USB storage device reader for use with the
Media Player. See
future software upgrades.
To use the Media Player, please connect USB
storage device to this port (See
MP is an abbreviation of Media Player.
LAN Port 1/2 (RJ-45)
page 47
Audio OUT
Internal/External Speaker Switch
: Internal speaker
: External speaker.
External Speaker Terminal
USB Upstream
page
21. This port is for
page
18).
and
page
50.
Advertisement
Table of Contents
