Table of Contents
Advertisement
3. Installing and Removing the Optional
Table Top Stand
CAUTION: • Installing and removing the stand must be
done by two or more people.
• ONLY use screws which are supplied with
the optional table top stand.
• When installing the monitor stand, handle
the unit with care to avoid pinching your
fingers.
For installation, follow the instructions included with the
stand or mounting equipment. Use only those devices
recommended by the manufacturer.
NOTE:
• Use the ST-401. Please refer to the ST-401
user's manual for more detail.
• DO NOT use this monitor on the floor with the
table top stand. Please use this monitor on a
table or with a mounting accessory for support.
CAUTION: Please refer to the table top stand manual of
ST-401 for "structure of Prevent Tipping".
Height adjustment
1. The lines on the stand pole are indicators of the height
adjustment (Figure 3). Please adjust the pipe to the lines.
V554Q High/Low
Adjust the pipe to a line.
Figure 3
300 mm
Pipe
English-8
2. Please install the stand pole and the pipe with included
screws. Please screw the two screw holes at the pipe
(Figure 4).
Pipe
Figure 4
CAUTION: Installing the monitor at the wrong height can
cause tipping.
Please install your monitor at proper height.
4. Ventilation Requirements
When mounting in an enclosed space or recessed area,
leave adequate room between the monitor and the enclosure
to allow heat to disperse, as shown below.
100 mm
100 mm
Must be under 40 Degree Celsius.
Allow adequate ventilation or provide air conditioning around
the monitor, so that heat can properly dissipate away from
the unit and the mounting equipment; especially when you
use monitors in a multiple screen configuration.
NOTE:
The sound quality of the internal speakers will be
different depending on the acoustics of the room.
Stand pole
30 mm
Advertisement
Table of Contents
