Table of Contents
Advertisement
Changing NEC logo ornament position
When using the monitor in the portrait position, the NEC logo
ornament position can be changed.
Removing the logo ornament: unscrew the installed screw
then take off the logo ornament.
Attaching the logo ornament: adjust the protrusions inside
of the logo ornament into the protrusion holes on the bezel.
Make sure the hole for the screw on the logo ornament and
the hole for the screw on the bezel are aligned. Install the
logo ornament with the screw, which is used for installing the
logo ornament.
(Recommended Fasten Force: 30-40N•cm).
Screw hole
Protrusion hole
Screw hole
Protrusion
Inside of NEC logo ornament
CAUTION: Do not use any other screw to install the logo
ornament.
Attaching Mounting Accessories
The monitor is designed for use with the VESA mounting
system.
1. Attach Mounting Accessories
Be careful to avoid tipping the monitor when attaching
accessories.
VESA Mounting Interface (M6)
300 mm
Mounting accessories can be attached with the monitor in
the face down position. To avoid scratching the LCD panel,
always place a soft cloth, such as a blanket that is larger
than the monitor's screen area, on the table before laying the
monitor face down. Make sure there is nothing on the table
that can damage the monitor.
Protrusion hole
Protrusion
When using mounting accessories other than NEC compliant
and approved, they must comply with the VESA Flat Display
Mounting Interface Standard (FDMI).
NOTE:
Prior to installation, place the monitor face down
on a flat even surface that is larger than the
monitor screen.
Use a sturdy table that can easily support the
weight of the monitor.
2. Installing an Option Board
1. Turn off the main power switch.
2. Place the monitor face down on the protective sheet.
NOTE: Be sure to place the monitor on a flat and adequate
space.
3. Remove the attached slot cover by unscrewing the
installed screws (Figure 1), sliding to right (Figure 2) and
moving up (Figure 3).
Figure 1
Figure 3
4. Insert the Option Board into the monitor and fix it with the
removed screws (Figure 4).
NOTE:
Please contact your supplier for a list of Option
Boards available for your monitor.
Do not apply excessive force to manipulate the
Option Board before fixing it with screws.
Make sure that the board is inserted into the slot in
the correct orientation.
WARNING: Ensure the Option Board is attached by the
removed screws. Otherwise, the Option
Board may fall out and expose you to danger.
(Recommended Fasten Force: 139 - 189N•cm).
English-7
Figure 2
Figure 4
Advertisement
Table of Contents
