Yamaha Electone EL-500 Owner's Manual page 60

NOTE:
Though independent Tune, Pan, Reverb
and Volume settings can be made each
instrument, only one set of settings is
available. (Settings cannot be memorized
to Registration Memory.)
5
The changes made here affect the entire
instrument settings including the Preset/
User rhythm patterns and Keyboard
Percussion. Consequently, you may
unintentionally have modified the
settings you didn't want to change.
Executing the Copy Preset (shown
below) operation returns you to the
factory preset settings.
NOTE:
The volume of the voice section(s) on
the keyboard on which you want to set
an instrument should be turned off.
NOTE:
Loading the registration data created on
the ELX-1 will set the Pan, Reverb and
Volume settings to the values set for the
ELX-1 and reset the Tune setting to the
factory preset value. Using registration
data created on other Electone models
will restore all Instrument Page settings
to the factory preset status.
NOTE:
Refer to page 125 for the instrument
assignments of each set.
2) To select the Instrument page:
Choose a rhythm, and press that pattern's panel button again (or again press
the Data Control button corresponding to the selected rhythm) to display the
Rhythm Condition page. Then press the Page buttons to select INST.
(Instrument) page.
Instrument Page
1
2
In this page, individual drum and percussion sounds used to make up the
Rhythms and Keyboard Percussion can be given independent settings.
1 Instrument Name
This shows the name of the currently selected instrument. To select a
different instrument, press the key or pedal to which the sound is
assigned. (Refer to page 125 for instrument/key assignments of the
Rhythm Pattern Program.)
2 TUNE
Determines the pitch of the currently selected instrument.
Range: -6 - 0 - +6
3 PAN
Determines the position of the currently selected instrument in the
stereo image. Seven pan positions are available.
4 REV. (Reverb)
Determines the amount of reverb applied to the currently selected
instrument.
Range: 0 - 24
5 VOL. (Volume)
Determines the fine volume setting of the currently selected
instrument.
Range: 0-24
6 ASSIGN (NORMAL/EXTEND)
Selects the instrument set you want to use. Two types are available:
NORMAL: Selects the instruments assigned to the Upper/Lower
keyboards.
EXTEND: Selects the instruments which are normally assigned to
the outside of the keyboard range.
7 COPY./PRESET
Replaces the current user settings with the factory preset settings.
60
3 4 5 6 7