Digital Cascade Kit (Cd8-Cs) - Yamaha 02R Owner's Manual

Digital Cascade Kit (CD8-CS)

The digital cascade kit (CD8-CS) is used to connect two or more Digital
Recording Console 02R units together. The kit consists of two cascade I/O
cards and a special cable. When two or more 02R units are connected
together, they share the output buses 1 through 8, four auxiliary buses (two
paired buses, AUX A and AUX B), the stereo bus, and the solo bus.
SYNC
Digital MTR
SYNC
(Word clock master)
Digital MTR
(Word click
slave)
WORD
CLOCK
SLOT 1 SLOT 2 IN
02R cascade slave (Word clock slave)
75Ωswitch＝ON
Installing the CD8-CS
The cascade I/O card (CD8-CS) is a single slot card. At least one cascade
I/O card should be installed in each 02R. If you are connecting more than
two units, the middle units should have two cards. The cascade I/O cards
should be installed in SLOT3 or SLOT4. You should reserve SLOT1 and
SLOT2 for digital I/O cards.
For installation instructions, see "Single Slot Cards" on page 175 of the
User's Guide.
1. Set the IN/OUT switch of the cascade I/O card installed in the first
02R to the IN position.
This unit will be the cascade master.
2. Set the IN/OUT switch of the cascade I/O card installed in the
second 02R to the OUT position.
This unit will be the cascade slave.
WORD CLOCK OUT
OUT IN
CD8-CS
WORD
CLOCK
SLOT 4 SLOT 4
OUT
02R cascade slave (Word clock slave)
Digital Recording Console 02R User's Guide
Installing Options
Digital MTR
(Word clock slave)
Digital MTR
(Word clock slave)
WORD
CLOCK
IN
SLOT 2 SLOT 1
75Ωswitch＝ON
183
SYNC