Digital Cascade Kit (Cd8-Cs) - Yamaha 02R Version 2 Manual

Digital Cascade Kit (CD8-CS)

The digital cascade kit (CD8-CS) is used to connect two or more 02Rs
together. The kit consists of two cascade I/O cards and a special cable.
When two or more 02Rs are connected together, they share the output
buses 1 through 8, four auxiliary buses (two paired buses, AUX A and
AUX B), the stereo bus, and the solo bus.
SYNC
Digital MTR
SYNC
(Word clock master)
Digital MTR
(Word click
slave)
WORD
CLOCK
SLOT 1 SLOT 2 IN
02R cascade slave (Word clock slave)
75 switch ON
Installing the CD8-CS
The cascade I/O card (CD8-CS) is a single slot card. At least one cascade
I/O card should be installed in each 02R. If you are connecting more than
two 02Rs, the middle units should have two cards. The cascade I/O cards
should be installed in SLOT3 or SLOT4. You should reserve SLOT1 and
SLOT2 for digital I/O cards.
For installation instructions, see "Single Slot Cards" on page 221 of the
User's Guide.
1. Set the IN/OUT switch of the cascade I/O card installed in the first
02R to the IN position.
This 02R will be the cascade master.
2. Set the IN/OUT switch of the cascade I/O card installed in the
second 02R to the OUT position.
This 02R will be the cascade slave.
WORD CLOCK OUT
OUT IN
CD8-CS
WORD
CLOCK
SLOT 4 SLOT 4
OUT
02R cascade slave (Word clock slave)
Installing Options
Digital MTR
(Word clock slave)
Digital MTR
(Word clock slave)
WORD
CLOCK
IN
SLOT 2 SLOT 1
75 switch ON
02R User's Guide
229
SYNC