Yamaha 02R Owner's Manual page 295

5. Use the CURSOR buttons to select the wordclock source.
If your multitrack digital recorder has a dedicated wordclock output
connector, use the CURSOR buttons to select the W.CLK IN box and
press the [ENTER] button. Otherwise, select a box from the appropriate
I/O slot row and press the [ENTER] button.
6. When you select the wordclock source, the corresponding icon
should be inverted in reverse video.
See "Word Clock Select" on page 154 of the User's Guide for further
details.
Cascade Settings
1. On the 02R cascade master, press the [DIGITAL I/O] button until
the "Cascade Configuration" screen appears.
2. Select the "ID" field with the CURSOR buttons and rotate the
encoder wheel until the appropriate value is set.
The cascade master should have the highest ID number in the system.
If you have four 02R units cascaded together, the cascade master
should be set to ID=3.
Note: If you connect more than four 02R units together, you will have to
adjust the delay to compensate for signal processing time. See "Delay and
Cascade" on page 34 of the User's Guide.
3. On the 02R cascade slave, press the [DIGITAL I/O] button until the
"Cascade Configuration" screen appears.
If the cascade slave and cascade master units are powered on and
connected correctly, the ID number for the cascade slave is set to the
appropriate value automatically.
4. Use the CURSOR buttons to select the "Cascade Aux Bus Assign"
field.
Use the CURSOR buttons to select two pairs of auxiliary buses from
the cascade slave to send to the cascade master AUX A and AUX B
buses.
Note: It is not possible to send the same pair of auxiliary buses from the
cascade slave to both AUX A and AUX B on the cascade master.
See "Cascade Configuration" on page 157 of the User's Guide for
further details.
Installing Options
Digital Recording Console 02R User's Guide
185