Yamaha 02R Owner's Manual page 240

130 Automation
...continued
8. Use the CURSOR buttons
to select the "Edit Out"
RETURN check box and
press the [ENTER] button
to change its value.
9. Select a "Fader Edit
Mode" check box with
the CURSOR buttons and
press the [ENTER] button.
Digital Recording Console 02R User's Guide
Time Code Display
The 02R displays the received timecode in this large area on the screen. If
you select INT (internal) timecode, the timecode display immediately
starts to count the time. You can reset this value with the "INT Start Time"
field.
Communication Speed
You can set the communication speed to a computer plugged into the
TO HOST connector on the back of the 02R. The default speed is
38.4 kbps (kbaud), indicated by clock 1. This connector is used by a
computer running the Project Manager software.
Timecode Type and Frame Rate
Select the timecode type from the following list:
• SMPTE timecode
• MTC (MIDI timecode)
• Internal (INT) timecode
Select the timecode frame rate from the following list:
• 24 frames per second.
• 25 frames per second.
• 29.97 frames per second (30 drop frame).
• 30 frames per second.
Automix ENABLE
When the 02R receives timecode during enable status (box checked), it
will start playback of the AUTOMIX (or recording if it is in REC ready
mode). If the 02R is in disable status, the AUTOMIX will not function.
Overwrite Mode
The automation system can record the following parameters: FADER,
CH ON, PAN, or EQ. The FADER parameter includes the AUX send
level. You can select whether or not to overwrite one of these four
parameters.
Use the [SEL] button to select which channel the parameter is to be
recorded from. The parameter will be overwritten during the record
operation. During the overwrite operation, the [SEL] button will flash.
During automation recording, you cannot change a parameter settings
unless the corresponding parameter has been selected and the channel