Related Manuals for Prorack PR3077
Summary of Contents for Prorack PR3077
- Page 1 PR3077 Eyebolt Fitting Instructions for Basic Carrier Revision No: 2C...
-
Page 2: First Time Installation
Eyebolt PR3077 First Time Installation Remove parts from inside the package and check. Contact your dealer if any parts are missing or damaged. This kit fits type A , B and D only. For type A and B crossbars only. - Page 3 Eyebolt PR3077 For type B, unfasten security screw with an Hex Key and lift the accessory tab up. Push down rubber infill. Slide square nut along channel. Position where you want the accessory to...
- Page 4 Eyebolt PR3077 Assemble washer with Eyebolt. Screw the Eyebolt into the nut. For type D and Tradesman crossbars only. Place spring nut into crossbar channel. Position where you want the accessory to...
- Page 5 Eyebolt PR3077 Push down and twist spring nut to lock into place. Assemble washer with Eyebolt. Screw the Eyebolt into the nut.
-
Page 6: Maintenance
Eyebolt PR3077 Maintenance Clean the car roof and surfaces of the product that will be in contact with the car roof. Follow the fitting instructions for fitting the product to your vehicle. Make sure all steps are carried out in order. - Page 7 Eyebolt PR3077 Check and replace worn out or defective parts. Keep the product clean and maintained. Never drive into a car wash with the roof rack system fitted. Lubricate locks and adjusting screws at regular intervals. Remove the products from the vehicle when not in use.
-
Page 8: Warranty And Disclaimer
Make a claim as soon as practicable by contacting the Prorack dealer from whom you purchased the product, who will give you instructions on how to proceed. If you are unable to contact the Prorack dealer, or the dealer is not able to remedy the defect, you should contact Yakima as soon as practicable at: Call: 0800 4776 722 (NZ) or 1800 143 548 (AU) Email: warranty@yakima.co.nz or warranty@yakima.com.au... - Page 9 Yakima or the Prorack dealer will be borne by you. Following receipt of the product and purchase invoice or receipt, Yakima or the Prorack dealer must inspect the product to determine whether the claim falls within the warranty. If: 4.1 the claim falls within the warranty, Yakima will remedy any defects in materials or workmanship becoming apparent during the...
Need help?
Do you have a question about the PR3077 and is the answer not in the manual?
Questions and answers