Prorack PR3302 Manual

2-Bike Strap Rack
2 bike capacity
3-Bike Strap Rack
3 bike capacity
Purchase separately:
A Bike Frame Adapter is required
for step through/ladies frames or
bikes with slanted top tubes.
Some vehicles CANNOT SAFELY accept any rear strap rack.
• If your car has a severely curved boot or hatch lid, the carrier's strap hooks may slide to the side, causing
your mount and bicycles to fall from your vehicle. If your car's boot or hatch edge is severely curved,
DO NOT USE THIS PRODUCT.
• Some boot or hatch lids may not be able to accept the hooks that hold the carrier on your vehicle. Make
NO ATTEMPT to modify the hooks to fit your vehicle, it may damage your vehicle and/or cause the carrier
to fall from the vehicle. If your straps are too short to tie knots behind the buckle, DO NOT USE THIS PRODUCT.
• Some vehicles use lighter weight materials in the boot or hatch area. Check the integrity of the hatch to
ensure the carrier's lower frame will not dent your vehicle. If your vehicle has a boot or hatch that is
plastic where the lower frame, upper frame or hooks contact, DO NOT USE THIS PRODUCT.
• Some vehicles are equipped with a rear mounted spoiler that may interfere with the upper frame or
upper hook placement. If your vehicle has a spoiler and this product interferes in any way, DO NOT USE
THIS PRODUCT as the carrier may not mount safely and consequently damage your spoiler.
• Some vehicles are equipped with rear windshield wipers. Make sure the mount does not interfere.

IMPORTANT WARNING

IT IS CRITICAL THAT ALL PRORACK RACKS AND ACCESSORIES BE PROPERLY AND SECURELY ATTACHED TO YOUR VEHICLE.
IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR
DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR SECURING THE RACKS AND ACCESSORIES TO YOUR CAR, CHECKING
THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE.
THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR PRORACK
PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF
YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU
SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER SUCH AS A QUALIFIED GARAGE OR AUTO BODY SHOP.
Rev1
2 & 3-Bike Strap Rack
See page 2 for more information
on numbered items
Security strap
Cylinder hook
adapters
1 Lower frame
2 Upper frame
3 Top hook
4 Bottom hook
5 Side hooks
6 Support arms
7 Control block
8 Fastener Strap
9 Hub cap
10 Cam lever
Page 1 of 6