Page 1
• Please read instructions carefully before installation. • Check the contents of kit. Contact your Prorack dealer if any parts appear to be missing or damaged. • Clean your roof racks/Aero Deck prior to fi tting the Utility Mount kit.
Page 2
Installation 20 mm 25 mm 25 mm 16 mm INSTALLATION ONTO POSITION NUTS IN CHANNEL RECOVERY TRACKS OR ACCESSORY Determine the best spacing for the Utility Mounts based on the tool you will be MOUNTING BRACKETS carrying. For crossbars, it is recommended to position Nuts close to the end of crossbars and ensure they are equally spaced as shown.
Page 3
Installation to Aero Bars INSERT CAPSCREWS INTO UTILITY MOUNT Assemble 1 x Star Washer onto each Capscrew. Insert Capscrew assemblies through hole in the base of each Utility Mount as shown. POSITION AND SECURE UTILITY MOUNTS Line up Capscrews in the base of each Utility Mount into the nuts in Bar channel. Tighten all Capscrews to 4 Nm with Allen Key provided.
Page 4
Installation to Aero Deck and HD Bars INSERT CAPSCREWS INTO UTILITY MOUNT Assemble 1 x Star Washer onto each Capscrew. Insert Capscrew assemblies through hole in the base of each Utility Mount. ADD SLOT NUT TO HOLDER Add Slot Nut to Capscrew with 1.5 turns until fl ush. Page 4 of 8 6100015541_PR3715-Rev6...
Page 5
SECURE UTILITY MOUNT TO AERO DECK AND HD BARS For Aero Deck installation insert Slot Nut into the Aero Deck as shown. Slide to location. Tighten to 4 Nm. For HD Bar installation turn slot nut to be parrallel with slot on HD Bar. When conveniently located turn the slot nut 90 Degrees.
Page 6
Ensure any blades are orientated towards the rear of the vehicle and facing up or away from you. The Utility Mounts can accommodate long handled items with a 30-55 mm shaft diameter including axes, rakes, brooms and oars to a maximum weight of 4 kg. Prorack Aero Deck Vehicle Rear Prorack Bars...
Page 7
TOOL REMOVAL To release, unlock the unit using the keys provided (if needed), and then squeeze the side tabs while pulling the top claw upwards. WHEN NOT IN USE When not carrying an item, close both holders completely to secure rubber pads in place. If rubber pads are lost, order item SP209 for a replacement kit.
Page 8
Never drive into a car wash with the roof rack system or accessories fi tted. • Do not exceed the vehicle manufacturer’s roof load rating. Total load equals weight of roof racks + accessories + cargo/ equipment. Prorack Freephone 17 Hinkler Court, Brendale AU: 1800 143 548 www.prorack.com.au...
Need help?
Do you have a question about the PR3715 and is the answer not in the manual?
Questions and answers