Redarc BMS1230S2-NA Manual page 16

2 INSTALLATION GUIDE
Removing the Remote Monitor
1
The locking tabs on the back of the
Inner Assembly need to be unclipped
from the Back Plate.
3
Insert a flat-head screwdriver at a
slight angle towards the front of the
Remote Monitor and push back to
depress the locking tabs.
5
Slide fingers between the Front Face
and the Inner Assembly in positions
marked above and carefully pull
back towards the front of the
Remote Monitor.
Figure 2.2.2.3 - How to remove the
Remote Monitor.
15
2
The locking tabs can be accessed
through holes on the top of the
backing plate when installed.
4
When the screwdriver is in a vertical
position, gently push upwards on the
bottom of the Remote Assembly to
unlock tab. Repeat 3 & 4 for 2
6
Remove the Remote Monitor cable
and the Inner Assembly is removed.
tab.
nd