Advertisement
S T E P
1
Be careful to assemble all components
in the sequence they are presented.
NOTE:
Wrench tighten ALL hardware at the end of each step . Some components may be
pre-assembled. Nylon lock nuts will not fully screw onto bolts, they must be wrench
tighten to fully go on.
1A. Attach four Rubber Feet (14) to Base Frame (A) using:
8 - (#6) M4x20mm Flat Head Phillips Screw
1B. Attach two Front Weight Horns (E) to Base Frame (A) using:
2 - (#3) M10x75mm Hex Head Bolt
2 - (#7) M10 Washer
1C. Attach two Rear Weight Horns (F) to Base Frame (A) using:
2 - (#2) M10x90mm Hex Head Bolt
4 - (#7) M10 Washer
2 - (#8) Nylon Lock Nut
1D. Insert Rubber Donuts (18) onto Rear Weight Horns (F)
10
Advertisement
