Preparing The Remote Control; Inserting And Removing The Batteries; When Using The Multiple Projectors - Panasonic DLP PT-FRZ60 Operating Instructions (Functional Manual)

Preparing the remote control

Inserting and removing the batteries

(i)
1) Open the cover. (Fig. 1)
2) Insert the batteries and close the cover (insert the m side first). (Fig. 2)
f When removing the batteries, perform the steps in reverse order.

When using the multiple projectors

When you use the multiple projectors together, you can operate all the projectors simultaneously or each projector
individually using single remote control, if a unique ID number is assigned to each projector.
When using the projectors by setting the ID numbers, set the ID number of the projector body after initial settings
have been completed. Then, set the ID number of the remote control. For initial settings, refer to "When the initial
setting screen is displayed" ( x page 41).
The factory default ID number of the projector (projector body and remote control) is set to [ALL], so you can use it
as it is. Set the ID numbers of the projector body and remote control as necessary.
For details on setting the ID number of the remote control, refer to "Setting ID number of the remote control"
( x page 55).
Note
f Set the ID number of the projector body from the [PROJECTOR SETUP] menu → [PROJECTOR ID].
28 - ENGLISH
Chapter 1 Preparation — Preparing the remote control
(ii)
Fig. 1 Fig. 2