Switching On The Projector - Panasonic DLP PT-FRZ60 Operating Instructions (Functional Manual)

Chapter 3 Basic Operations — Switching on/off the projector
Indicator status
Red
Green
Orange
Note
f While the power indicator <ON (G)/STANDBY (R)> lights orange, the fan is running to cool the projector.
f For approximately five seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks red.
f The projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks red). Refer to "Power
consumption" ( x page 182) for the power consumption.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
f The power indicator <ON (G)/STANDBY (R)> will blink green slowly while the shutter function is in use (shutter: closed), or while the function
of the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [AUTO POWER SAVE] → [NO SIGNAL LIGHTS-OUT] is operating and
the light source is turned off.

Switching on the projector

1) Connect the power cord to the projector.
2) Connect the power plug to an outlet.
3) Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f The power indicator <ON (G)/STANDBY (R)> lights/blinks red, and the projector enters the standby mode.
40 - ENGLISH
The power is switched off. (standby mode)
Projection will start when the power < v / b > button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]
is set to [OFF]
Lit
g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is
set to [OFF]
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. ( x page 160)
The power is switched off. (standby mode)
Projection will start when the power < v / b > button is pressed.
f The projector is set to one of the following. Power consumption is high.
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]
is set to [ON]
g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is
set to [ON]
f The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set as following.
Blinking
The specified time is a time set in the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].
g The [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]
is set to [ON]
g The [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is
set to [OFF]
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. ( x page 160)
Lit Projecting.
The projector is preparing to switch off the projector.
Lit
The power is switched off after a while. (Changes to the standby mode.)
3)
1) 2)
Projector status
4)
4)