Serial In> Terminal - Panasonic DLP PT-FRZ60 Operating Instructions (Functional Manual)

Note
f The projector will automatically disconnect the connection with the network right after sending the command. This is the specification based
on the security view point to prevent unauthorized operation of this product by a malicious third party. To send commands continuously,
execute the network connection request every time the command is to be sent. For details, refer to "Communication flow between server
and client" ( x page 175).
Communication flow between server and client
To send/receive a command via LAN, refer to the communication flow indicated below.
Server: Projector
Client: Control device such as a computer
<SERIAL IN> terminal
The <SERIAL IN> terminal of the projector conforms with RS-232C so that the projector can be connected to and
controlled from a computer.
Connection
When connecting directly
When connecting using DIGITAL LINK compatible device
Projector connecting terminals
DIGITAL LINK
LAN cable (straight)
Note
f The destination of [RS-232C] ( x page 105) must be set according to the connection method.
f When connecting using a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY
MODE] to [NORMAL] to control the projector in the standby mode.
When [STANDBY MODE] is set to [ECO], the projector cannot be control during standby.
Chapter 7 Appendix — Technical information
Connection request
Sending of key
Sending of command 1
Session 1
Responding to command 1
Disconnection
Connection request
Sending of key
Sending of command 2
Session 2
Responding to command 2
Disconnection
Projector connecting terminals
D-Sub 9p (female)
D-Sub 9p (male)
DIGITAL LINK compatible device
DIGITAL LINK
Server
Computer
Communication cable (straight)
D-Sub 9p (female)
D-Sub 9p (male)
Communication cable (straight)
Computer
ENGLISH - 175