Control Commands Via Lan - Panasonic DLP PT-FRZ60 Operating Instructions (Functional Manual)

r RASTER PATTERN
Performance
No operation
OFF
WHITE
YELLOW
CYAN
GREEN
MAGENTA
RED
BLUE
BLACK
USER LOGO
No operation
r [AUDIO VOLUME]
Performance
No operation
Factory default setting
0
...
63
No operation
r ENABLE / DISABLE
Operation for all channels is not accepted when set to "Disable".
Performance
Disable
Enable
Note
f If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be different from the projector status. To reflect the controls
of all channels to the projector, set "ENABLE / DISABLE" of channel 11 to "Disable" and then back to "Enable".
f To create and register the USER LOGO image, use "Logo Transfer Software". The software can be downloaded from the Panasonic website
(https://panasonic.net/cns/projector/).

Control commands via LAN

The projector can be controlled via the <DIGITAL LINK/LAN> terminal or the <LAN> terminal by using the control
command format via the <SERIAL IN> terminal.
For examples of the available commands, refer to "Control command" ( x page 177).
Note
f Setting the password of the administrator account ( x page 123) is required for sending and receiving the commands via LAN.
When connecting in protected mode
Connecting
This is the connection method when [NETWORK] menu → [NETWORK SECURITY] → [COMMAND PROTECT]
is set to [ENABLE].
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f You can obtain both the IP address and the port number from the menu screen of the projector.
172 - ENGLISH
Chapter 7 Appendix — Technical information
Parameter
0-15
16-31
32-47
48-63
64-79
80-95
96-111
112-127
128-143
144-159
160-175
176-255
Parameter
0-31
32-63
64-65
...
190-191
192-255
Parameter
0-127
128-255
Default value
0
Default value
0
Default value
0