How To Change The Name Of Cycle/Continuous Sewing Data - JUKI LBH-1790AN Instruction Manual

4) Change data of selected editing point.
Press DATA CHANGE key ❼
Pattern No. which has been registered is displayed and it is possible to select.
In addition, press RESET key ❸
When RESET key ❸
Repeat steps 3) and 4) to perform editing data.
5) Cancelling insertion of the pattern data.
When RESET key ❸
the pattern data can be cancelled.
In addition, when READY key ❷
mode changes over to the sewing mode.
When RETURN key ❾
es over to the input mode.
6) Creating new cycle data

Press COPY key
key ❻
to select the new-creation pictograph. This enables the creation of new cycle data.
When you press DATA CHANGE key ❼
pattern number to be newly created can be selected.
Then, select the pattern number to be newly created and press READY key ❷
cycle data.

19. How to change the name of cycle/continuous sewing data

1) Putting the data name in the edit state.
Refer to "V-17. Performing continuous stitching" p.47
p.50.
2) Changing the name of data.
Refer to "V-11. Changing sewing data"
and data of editing point can be changed.
, and the pattern data of editing point can be deleted.
is held pressed for one second, all the registered pattern data can be deleted.
is pressed while the addition command pictograph is displayed, insertion of
is pressed, insertion of the pattern data is cancelled and the
is pressed, insertion of the pattern data is cancelled and the mode chang-
, under the input mode, to call the copy screen. Then, press ITEM SELECT
while the new-creation pictograph is being selected, the
p.34.
– 52 –
and "V-18. Performing cycle stitching"
to create new