Using Parameter Register Key - JUKI LBH-1790AN Instruction Manual

16. Using parameter register key

Register parameters which are frequently used with parameter register key and use them.
Parameters which have been registered can be selected by pressing only the parameter register key
under the input mode.
(1) Method of register
1) Set the mode to the input mode.
Under the input mode where SET READY LED 
goes out, parameter registration is enabled.
If the current mode is the sewing mode, press
READY key ❷
to the input mode.
2) Call parameter register screen.
Press MODE key ❹
screen. Select the parameter key registration
on this screen. Then, the parameter registration
screen A is displayed.
When you press EDIT key ❽
the parameter registration key setting screen is
displayed.
The parameter registration key setting screen
can also be displayed by keeping the parameter
registration key you want to edit held pressed.
3) Select parameter.
Item B which can be registered to the key is displayed. Press ITEM SELECT key ❻
item to be registered.
Items which can be registered are sewing data, parameters of memory switches (level 1) and pattern Nos.
In addition, when trash can
4) Start register.
When READY key ❷
When RETURN key ❾
registration.
(2) Register status at the time of your purchase
Register key
F1 Changeover of single/double stitching
F2 Basting (off/number of times)
F3 Basting needle thread tension setting
F4 Plural motions of cloth cutting knife
Ineffective/effective
F5 Cloth cutting knife size
to change over the mode
to display the mode
on the screen,
is selected, register can be released.
is pressed, registration starts, and the screen returns to the mode screen.
is pressed, the screen returns to the previous screen without performing
Registered parameter
– 46 –
❽
A B
 ❷
❾
❻
to select the