JUKI LBH-1790AN Instruction Manual page 42

No.
Pitch at bar-tacking section
S021
This item sets sewing pitch of bar-tacking section.
Top of
Top of
square
round
type
type
Bottom
Bottom
of square of round
type type
S022 1st clearance
This item sets the clearance between 1st bar-tacking
and knife groove. This item is applied to all shapes.
S023 2nd clearance
This item sets the clearance between 2nd bar-tack-
ing and knife groove.This item is applied to all
shapes.
S031 Single/double stitching
This item selects single or double stitching.
Double stitching cross selection
S032
This item selects overlapping stitching or cross stitching at the
needle entry of parallel section when setting double stitching.
: Double stitching
S033 Compensation of double stitching width
This item sets amount to narrow overedging width of
1st cycle when setting double stitching.
Number of times of basting
S034
This item sets number of times of basting.
: Without basting
S035 Basting pitch
This item sets pitch at the time of performing basting.
S036 Rolling length of basting
This item sets rolling length of needle thread when
performing basting.
S037 Rolling pitch of basting
This item sets rolling pitch of needle thread when
performing basting.
S038 Rolling width of basting
This item sets rolling width of needle thread when
performing basting.
S039 Lengthwise compensation of needle entry
of basting
This item sets the amount to move needle entry po-
sition back and forth when performing basting more
than two cycles.
*1 : Displayed according to the shape
*2 : Displayed when it is set to with edit. Refer to
*3 : Displayed when the function is selected.
Item
Top of
semilunar
type Bottom of
straight bar-
tacking
Bottom of
semilunar
type
Single Double
stitching stitching
: Cross stitching
: With basting
(Setting of number of times)
"V-12. Method of setting sewing data with/without edit"
Setting range
0.200 to 2.500
Bottom of
taper bar-
tacking
0.0 to 4.0
0.0 to 4.0
–
–
0.0 to 2.0
0 to 9
1.0 to 5.0
2.0 to 20.0
0.2 to 5.0
0.0 to 4.0
0.0 to 2.5
– 39 –
Edit unit Remarks
0.025 mm –
0.1 mm –
0.1 mm –
– –
*3
–
0.1 mm *3
1 time –
0.1 mm *3
0.1 mm *3
0.1 mm *3
0.1 mm *3
0.1 mm *2, *3
p.36.